METAL MASK APPLICATION PROCEDURES
PRODUCT DESCRIPTION
Metal
Mask is a single component
polyurethane coating that makes any metal surface look exactly like new bare
metal. Metal Mask is
non-porous and will not crack, chip, or peel when properly applied.
It has great scratch and abrasion resistance and is not sensitive to UV
light. Follow directions carefully and you will be rewarded with the
finest protective coating for metal available anywhere!
For
best results, when applying over bare metal, first prep your job with POR-15
Metal-Ready. Keep wet for
3–5 minutes, then wash off thoroughly with water and dry.
Stir contents of can well, then apply Metal Mask with a foam
brush. Try to avoid painting back
and forth. Apply in thin, covering
coats, using single, steady strokes to avoid “flooding” your job with too
much paint, which could cause it to ‘run’ and streak.
Continue to stir Metal Mask so that metallic pigments remain in
solution as you paint. SPRAY
APPLICATION: Use 25–30 lbs pressure for normal gloss.
Use only POR-15 Solvent for thinning.
Avoid skin contact. Remove from skin at
once to avoid temporary staining. USE
OF PROTECTIVE GLOVES AND VENTILATING EQUIPMENT IS RECOMMENDED.
NOTE: Organic vapor particulate respirators, NIOSH/MSHA approved,
must be used when spraying Metal Mask in a well-ventilated area.
When spraying in an enclosed area, air-supplied respirator must be used.
Moisture will shorten the life of unused Metal Mask.
Seal can immediately after using.
KEEP OUT OF THE REACH OF CHILDREN.
HARMFUL OR FATAL IF SWALLOWED. Use
in well ventilated areas only.
Hazardous Ingredients: Oil modified polyurethane, Cas:Proprietary, Aliphatic hydrocarbon, Cas#64741-41-9, Aluminum, Cas#1313-13-9, Iron Oxide, Cas#1309-37-1, Silicon Dioxide, Cas#7631-86-9, Aluminum Dioxide, Cas#1344-28-1
For additional information contact your POR-15 representative at
1-800-689-7504.