BLACK VELVET, FACTORY MANIFOLD GRAY, and POR-20 BRILLIANT ALUMINUM are Very High Heat-Resistant Coatings designed for use on steel subject to elevated temperatures. FACTORY MANIFOLD GRAY and POR-20 will withstand temperatures on a continuing basis up to 1400°F, while BLACK VELVET will will withstand temperatures on a continuing basis up to 1200°F. When subjected to high heat concentrations, FACTORY MANIFOLD GRAY will darken in color (as will cast-iron). Though they will dry to the touch in about four(4) hours and may be handled, these coatings will not arrive at full cure until they have been exposed to heat concentrations of at least 300 degrees Fahrenheit.

Metal Preparation: Surfaces to be coated must be clean, dry, and free from oil, grease, and any other coating which cannot resist high temperatures (paints, varnishes, lacquers, metal prep coatings, etc). Sandblasted surfaces are ideal, as are wire-brushed or sanded or filed surfaces. Surgical-type gloves should be worn for handling to keep natural body oils off the prepared surface.

Uses: Manifolds, Exhaust Systems, Ovens, Stacks, Stoves, Headers, Boilers.

 
PRODUCT DESCRIPTION

Thinner: For brush or spray, use only POR-15 Solvent. Lacquer thinner may be used for cleanup as may other aromatic solvents.

Dry Time: At 75 degrees Fahrenheit (24 degrees C), dry time is about four (4) hours to touch. Recoating may be done after a minimum of 24 hours. Attains full cure only after heat exposure of at least 300° Fahrenheit.

Special Application Technique:

Stir Factory Manifold Gray thoroughly before applying.
DO NOT SHAKE.
Apply in FULL coats rather than THIN coats, but not so full that it runs.
Avoid going over the same area again after it has been coated.
Keep away from heat, sparks, flame.
Use only in well-ventilated areas.
Avoid breathing vapors or spray mist, contact with eyes and skin.